Do It Yourself Pool Liner Installation

Step 1 prepare the pool prepare the pool for effective installation of the ground pool liner.

Do it yourself pool liner installation.

When the water is about four inches away from the edge you should shut the water off and start taking the pool apart. Unfold the liner inside the pool and drag the corners to the deep end and clip them in place. It is usually necessary to go around the pool every ten to fifteen minutes and let the liner down at each connection. If there are in pool steps that will be covered by the liner.

Set the liner into place and reassemble the pool. Clear the liner area by removing hung ladders and other equipment from the area. Now come back down the long sides of the pool. Unfurl your new pool liner and drape it across the pool lining it up in the very center.

Remember an installation manual is included with every pool and spa kit sold and if you have any questions our customer support personnel are ready to help answer. Generally the installation is started from the deep end and then going towards the shallow end. Drain all the water from the pool using a sump pump. Only remove three or four rails at a time.

Be sure to follow the instruction of the manufacturer when doing this. Installing an above ground pool liner is a project you can diy.